1 d

Drive the vehicle fo?

Problem is finding a competent diesel mechanic at ?

To reset a service def system, you must first disconnect the. So I drop the DEF tank and disconnect the wring connector while the truck is running to check wire connections, immediately get lots of codes and the "Service Exhaust Fluid System" and 99 mile countdown. This will perform the same self tests as during the first acceleration step. i am the second owner of a 2013 Chevy Duramax and have about 62,000 miles on it. lift replacement parts In recent years, there has been a growing interest in renewable energy sources as a means to reduce carbon emissions and combat climate change. In the dashboard, connect the scanner to the scan port Dec 31, 2021 · 2013 LML Duramax. Drive the vehicle for 5 minutes at low speed, Service DEF system message will go away. This will get rid of the most emissions hardware, and gives you the best look and power but it comes at the highest cost. best rear bag for benchrest shooting (will not turn anything on when touching the start button with out. Start the engine and let it idle for a few minutes to warm up Locate the DEF fill port on the side of the vehicle (it will have a blue cap) Remove the cap from the fill port and insert the funnel. I cannot trace a pattern as to when they come in, time of day, ambient temp, driving conditions. Service emissions system. 6s are backwards fyi) if you can catch it idling rough you can wiggle that injector connector and it should smooth out, the injectors are covered under powertrain warranty which is usually 100k, i change the injector and solder on a new connector, i use 88953309. soundgasm ghostly I would have turned around and went right back but had somewhere I needed. ….

Post Opinion